Panasonic PT-FRQ50

Chapter 5 Operations — Updating the rmware
188 - ENGLISH
10) Click [Start].
f
Update is started.
f
The temperature indicator <TEMP> and the light source indicator <LIGHT> on the projector blink red
alternately while updating.
f
Elapsed time and rough progress can be conrmed in the update status display screen. The required time
is approximately 15 minutes.
11) Confirm the completion of the update.
f
Once the update is completed, the completion conrmation screen is displayed.
f
To continue to update the rmware of another projector, click [Yes]. The connection setting screen in Step
7)
is displayed.
f
To end the update tool, click [No].
12) Confirm the firmware version.
f
Turn on the power of the projector and conrm the rmware version in the
[STATUS]
screen.
Attention
f
Do not disconnect the main power of the projector or disconnect the LAN cable while updating.
Note
f
In following cases, turn the power of the projector o󰀨 and on and perform the update from the beginning.
g
When the update does not complete after 60 minutes or more have elapsed
g
When the power of the projector or the computer has turned o󰀨 due to power outage, etc., during the update
Updating the rmware using the USB memory
Supported device
f
Commercially available USB memory is supported.
The USB memory with a security function is not supported.
f
Only the cards formatted in FAT16 or FAT32 can be used.
f
Only the single partition structure is supported.