Panasonic PT-FRQ50

Chapter 3 Basic Operations — Switching on/o󰀨 the projector
ENGLISH - 49
6) If the input signal is the analog RGB signal or the HDMI signal, press the <AUTO SETUP> button.
7) Turn the zoom ring to adjust the size of the projected image to match the screen.
8) Adjust the focus again with the focus ring.
9) Adjust the zoom again with the zoom ring to adjust the size of the projected image to match the
screen.
Note
f
When the projector is switched on for the rst time after purchase, or when the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed, the
[INITIAL SETTING]
screen is displayed after the projection starts, followed by the
[ADMINISTRATOR ACCOUNT]
screen. If the [PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed, the
[ADMINISTRATOR ACCOUNT]
screen is displayed after the projection starts. For details, refer to “When the initial setting screen is displayed” (
x
page 42), “When the
administrator account setting screen is displayed” (
x
page 47).
Switching o󰀨 the projector
1)
2)
1)
4)
3)
2)
1) Press the power <
v
/
b
> button.
f
The
[POWER OFF(STANDBY)]
conrmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the power <
v
/
b
> button again.)
f
Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f
For approximately ve seconds after the projector is turned o󰀨, the indicator does not light up even if the power is turned on.
f
Even when the power <
v
/
b
> button is pressed and the projector is switched o󰀨, the projector consumes power if the main power
of the projector is on.
When the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY MODE] is set to [ECO], use of some functions is restricted,
but the power consumption during standby mode can be conserved.
f
While projecting, the power can be turned o󰀨 by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched o󰀨/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned o󰀨 may not be reected.