ADJ-19
SECTION 3 ADJUSTMENTS
<RZ31K/RS30K>
3. Select [Setting] of [Option] menu, then select connection method and enter the setting information of the projector.
items Default value
SERIAL
Port –
Baud Rate 9600bps
Parity None
LAN
IP Address 192.168.0.8
Username admin1
Password panasonic
Command Port 1024
Serial terminal connection
• Select [SERIAL] menu and set up the Serial Port, Baudrate and Parity of the PC.
LAN terminal connection
• Select [LAN] menu and set up the IP address, Username, Password and Command Port of the projector.
[Note] • If the Username and Password has been changed, please select serial terminal connection.
4. After completing the connection setup, click the [Connection Check] button.
• When "Check : OK" is displayed, click the [OK] button and proceed to the next step.
• If "Check : NG" is displayed, check the setting in step 3.
In case of serial connectionIn case of LAN connection
To Next Page
Loading...
