Panasonic PT-RS30K

DIS-21
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
Heat dissipation compound :
Shin-Etsu Silicone [ G-776 ] grade 1g
[Note on mounting]
• Apply the heat dissipation compound evenly to
the rear surface of LD unit.
• Take care not to stick out the compound
Apply heat dissipa-
tion compound
2. 17. LD unit 2 removal
1. Remove the lighting block 2 following to the step [2.15. Lighting block 2 removal].
2. Unscrew 2 screws-A and remove the liquid cooling tank 2S.
3. Unscrew 1 torx screw-B and 5 screws-C, and remove the LD2S block (LD2S-1~6).
4. Unscrew 2 screws-D and remove the liquid cooling tank 2B.
5. Unscrew 1 torx screw-E and 5 screws-F, and remove the LD2B block (LD2B-1~6).
6. Unscrew each 4 screws-G or J and remove each LD unit.
Unscrew 1 screw-H or K and remove the thermistor on the LD unit (LD2S-2\LD2B-2).
Torque: 70±10 N•cm
H
K
Torque: 70±10 N•cm
G
J
Torque: 25 ~35 N•cm
B
C
A
E
F
D
LD2B block
LD2S block
Liquid cooling tank 2S
Radiator 2S
Radiator 2B
Lighting block 2
Liquid cooling tank 2B
G
J
H
K
LD unit
(LD2S-6)
(LD22-5)
(LD2S-4)
LD unit
(LD2B-4)
(LD2B-5)
(LD2B-6)
LD unit
(LD2S-3)
(LD22-2)
(LD2S-1)
LD unit
(LD2B-1)
(LD2B-2)
(LD2B-3)
ThermistorThermistor
A
D
B
E
C
F