Panasonic PT-RS30K

DIS-13
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
2. 7. Power PB block removal
1. Unscrew 6 screws-A, 2 screws-B and remove the power PB block.
2. Unscrew 4 screws-C, 2 screws-D and remove the circuit intake fan block.
3. Unscrew 2 screws-E and remove the LD driver 1 fan block.
A
B
CD
E
Circuit intake fan block
Power PB block
LD driver 1 fan block
Circuit
intake 1 fan
LD driver 1
fan
[M1]-P.C.Board
Circuit
intake 2 fan
[ P B ] - P.C. B o ar d
PB isolation sheet
bottom
PB isolation sheet
top
PB support metal
Signal board sup-
port sheet
Signal board sup-
port metal
B
A
C D
E
Ball point driver
Ball point driver
12
2
4
1