Panasonic PT-RS30K

DIS-24
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
Apply heat dissi-
pation compound
Heat dissipation compound :
Shin-Etsu Silicone [ G-776 ] grade 1g
G
J
H
K
LD unit
(LD1S-6)
(LD1S-5)
(LD1S-4)
LD unit
(LD1B-4)
(LD1B-5)
(LD1B-6)
LD unit
(LD1S-3)
(LD1S-2)
(LD1S-1)
LD unit
(LD1B-1)
(LD1B-2)
(LD1B-3)
ThermistorThermistor
H
K
Torque: 70±10 N•cm
G
J
Torque: 25~35 N•cm
2. 21. LD unit 1 removal
1. Remove the lighting block 1 following to the step [2.19. Lighting block 1 removal].
2. Unscrew 2 screws-A and remove the liquid cooling tank 1S.
3. Unscrew 1 torx screw-B, 5 screws-C and remove the LD1S block (LD1S-1~6).
4. Unscrew 2 screws-D and remove the liquid cooling tank 1B.
5. Unscrew 1 torx screw-E, 5 screws-F and remove the LD1B block (LD1B-1~6).
Torque: 70±10 N•cm
B
C
A
E
F
D
LD1B block
LD1S block
Liquid cooling tank 1S
Radiator 1S
Radiator 1B
Lighting block 1
Liquid cooling tank 1B
A
D
B
E
C
F
6. Unscrew each 4 screws-G or J and remove each LD unit.
Unscrew 1 screw-G or K and remove the thermistor on the LD unit (LD1S-2/LD1B-2).
[Note on mounting]
• Apply the heat dissipation compound evenly to the
rear surface of LD unit.
• Take care not to stick out the compound.