Panasonic PT-RS30K

DIS-6
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
2. Disassembly Instructions
[ Caution ]
• Before disassembly of the projector, turn off the power switch and disconnect the power plug from the wall outlet.
[Note]
• During the disassemble work, please wear gloves to protect your hands from metal parts and shield plate.
• Electrical parts such as PCBs, may get damaged by electro-statics discharge and surges which affects the set reliability.
Please take care for electro-static discharges by using grounded wrist straps to release the electricity from the body.
• When tore off sticky tapes, use a new thing without reusing it on the occasion of assembling.
2. 1. Fine coaxial cable connector
2. 1. 1. Installation requirements
• Fine coaxial cable are connected connector DG-P.C.Board (connector DG21-DG26) and FM-P.C.Board (connector
FM1,FM2).
• Connect the black mesh sleeve side to FM-P.C.Board. Please be careful when connecting.
Black mesh sleeve side
(Connect to FM-P.C.B)
Fine coaxial cable (50pin)
Fine coaxial cable (40pin)
Signal block
D G - P.C . Boa r d
connector DG21-DG26
DMD block
FM-P.C.Board[B]/[G]/[R]
connector FM1 and FM2
Note:
To prevent misconnecting of the ne coaxial cables, it is recommended to mark up with magic pen on the connector