DIS-20
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
2. 16. Liquid cooling unit 2 removal
1. Unscrew 2 screws-A and remove the liquid cooling tank 2S.
2. Unscrew 4 screws-B and remove the heat receiving plate 2S/liquid cooling pump 2S and then remove the liquid cooling
unit 2S.
3. Unscrew 2 screws-A and remove the liquid cooling tank 2B.
4. Unscrew 4 screws-B and remove the heat receiving plate 2B/liquid cooling pump 2B and then remove the liquid cooling
unit 2B.
[Note on mounting]
• Apply the heat dissipation compound evenly to the rear
surface of liquid cooling pump and heat receiving plate.
• Take care not to stick out the compound.
Apply heat dissipation
compound
Heat dissipation compound :
Shin-Etsu Silicone [ G-776 ] grade 1g
Torque: 70±10 N•cm
2. 15. Lighting block 2 removal
1. Unscrew 5 screws-A, 1 screw-B, 2 screws-C and remove the lighting block 2 upward.
Lighting block 2
A
B
C
Torque: 70±10 N•cm
[RP]-P.C.Board
[ R T ] - P. C . B oa r d
B
A
C
D
Liquid cooling
pump 2S
Liquid cooling pump 2B
Heat receiving
plate 2S
Heat receiving plate 2B
Liquid cooling tank 2S
Radiator 2S
Radiator 2B
Lighting block 2
Liquid cooling tank 2B
A
C
B
D
To Next Page
Loading...
