Panasonic PT-RS30K

DIS-7
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
2. 1. 2. Removal and insert procedure
Removal procedure of fine coaxial cable connector
Insert procedure of fine coaxial cable connector
• Hold both ends of cable connector, and pull out a vertical direction to
the circuit board.
• Do not pull on cable.
1) Set the cable side connector onto the board side connector.
2) Press the cable connector around the center of it until it makes the clicking sound.
3) Press the both edges of connector to fix firmly and check that it is not inclined.
[ Notes when removing the signal block ]
• Remove the signal block in a state in which a fine coaxial cables was protected. (See FIG)
• Please be careful not to hook the connector of fine coaxial cable to the circuit component.
• When fine coaxial cable wiring, please note that there is no tension.