ADJ-21
SECTION 3 ADJUSTMENTS
<RZ31K/RS30K>
8. If the version of the software is correct click the [OK] button and start updating.
[Note]
• During updating, the LED indicators on the projector will light as the below
ON/STANDBY LIGHT1 LIGHT2 TEMP
Main Lit in red Blink in red each others OFF
Sub OFF Lid in green (all) OFF
FRC Lid in green Lid in red (all) Lid in red
LDdriver Lid in green Lid in red (all) Lid in red
Formatter Lid in green Lid in red (all) Lid in red
DIGITAL LINK Lid in red Blink in red each others OFF
9. After finishing the updating, the confirmation message is displayed. Click [OK] button.
10. Click [EXIT] button to quit the application.
* Restart the main power of projector, and check that the version of software is updated definitely
Display the sub menu [STATUS] form the main menu[PROJECTOR SETUP:] and confirm the version of each software. As
the software of DRC, Formatter, DIGITAL LINK, LD Driver are displayed in the service mode only, enter the service mode
first and check the version of them in the [STATUS] menu.
To Next Page
Loading...
