Panasonic PT-RS30K

DIS-27
SECTION 2 DISASSEMBLY PROCEDURES
<RZ31K/RS30K>
6. Unscrew 1 screw-K, 4 screws-L and remove the liquid cooling tank support metal.
7. Unscrew 8 screws-M and remove the DMD radiator from the intake duct block.
8. Remove the DMD block/liquid cooling unit.
K
L
M
[M1]-P.C.Board
Liquid cooling support
metal
Intake fan block
Intake duct block
DMD block/Liquid cooling unit
[F]-P.C.Board
Intake 1 fan
Intake 2 fan
Ball point driver
[RD]-P.C.Board
DMD block/Liquid cooling unit
Liquid cooling support metal
DMD xing spring
DMD radiator pump
8
3
2
K L
M
4
[Note on mounting]
• Apply the heat dissipation compound evenly to the rear
surface of DMD radiator pump.
• Take care not to stick out the compound.
Heat dissipation compound :
Shin-Etsu Silicone [ G-776 ] grade 0.15g