Panasonic SA-PM250EB - Service Mode; Self Diagnostic Table

14
6 Service Mode
This unit is equipped with features of self diagnostic & doctor mode setting for checking the functions & reliability.
6.1. Self Diagnostic Table
Self Diagnostic Mode To enter into self diagnostic
checking
Item
FL display Key operation
Mode name Description
Error code information
Delete Error code
Example:
System will perform a check on
any unusual/error code from the
memory
To clear the stored in memory
(EEPROM IC)
Opecon version
Cold Start
To display model name & version
Model Name
PM250
Version display
_4HA
Step 1 : Select CD mode
(Ensure no disc is inserted).
Step 2 : Press and hold [ ] follow by
[ -PAIRING] on main unit
for 2 second .
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
Step 1 : In self diagnostic mode,
Press [STOP] on main unit.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
Step 1 : In self diagnosis mode,
press and hold [OK] on
remote control for more than
5 second.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
No Rom correction
Version display
(Display 1)
(Display 2)
Press [DISPLAY] button on the
remote control.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
Press [SETUP] button on the remote
control.
• To exit, press the [TA] on the main
unit or using the remote control.
• Unplug the AC cord.
To activate cold start upon next
power up.
(Backup data are initialized)