10
Before Using This System
Introduction For Use
Wiring
Observe the following items to distribute cables:
● Make sure to carry out the installation and the wiring in the power supply off condition.
● Be sure to use the specied S-LINK V cables, CC-Link cables, or DeviceNet cables.
● To protect the cables from noise, shorten the cable length as far as possible.
● Do not run the wires together with high-voltage lines or power lines or put them in the same raceway. This
can cause malfunction due to induction.
● Do not completely fold down any cables.
● Do not pull any cables with a strong force.
● Do not apply any weight to any cable.
● Do not touch a cable to any other system cables. This is because signals of different systems may interfere
with each other.
● Take care that wrong wiring damage the sensor.
Others
● Apply the specied torque to tighten the terminal screws.
● Check the connectors for looseness.
● Do not disassemble or modify this product.
● Before touching this product, be sure to discharge the static electricity from your body. This is because
static electricity on your body may damage the product.
● Design the system so that the system protective devices and safety circuits are outside the system.
Instructions for Disposal
● Request a waste disposal company to dispose of this product.
To Next Page
Loading...
Need help?
General
