Panasonic SL-VGU1-C

50
Chapter 2
Starting
Displaying number
of stations
ENTER
ENTER
Setting of error 1
output operation
Setting of error 2
output operation
Setting of error 3
output operation
Setting of error 4
output operation
Setting of error 5
output operation
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Default setting
Default setting
ENTER
ENTER
Output hold / clear
System setting
A B
Press and hold
ENTER key for 3 seconds.
Press and hold
ENTER key for 3 seconds.
Setting error
If the buffer memory assignment data, number of I/O control points, and the I/O setting data are not set properly,
the number of stations will not be displayed.
(If data is set properly, the number of stations will appear.)
In this status, if system setting or switching to the RUN mode is carried out, a setting error will be caused.
Lights up alternately.
Follow the procedure below to cancel the setting error:
● Setting error caused during system setting : Press ENTER key and SELECT keys (2 types of keys)
at the same time.
● Setting error caused during transition to RUN mode : Return to the CONFIG mode.
Note: If a setting error occurs, the CC-Link and S-LINK V system will not start transmission.