Panasonic SL-VGU1-C

56
Chapter 2
Starting
Programming
At the rst SL-VGU1-C, if the input of address 0 is turned on, the output of address 128 will be turned on.
At the second SL-VGU1-C, if the input of address 0 is turned on, the output of address 256 will be turned on.
(In the RUN mode, one time of scanning is carried out.)
(Remote READY status)
(Completion of transmission frame check)
(Completion of transmission frame check)
(Transmission frame check request)
M9038
M123
(Remote READY status)
M1123
M0
M1400
M430
M1014
M1014
M430
TO Setting of number of connected nodes
Setting of station number of 1st controller
Setting of station number of 2nd controller
Refresh command
Starting of data linking using parameters assigned to buffer memory
Reading of RX data from 1st controller
(112 input points + 1 word)
Reading of RX data from 2nd controller (3 words)
Reading of RWrm data from 1st controller
(16 input points + 2 words)
Writing of RWwm data in 1st controller (1 word)
Writing of RY data in 1st controller
(112 output points + 1 word)
Writing of RWwm data in 1st controller (16 output points)
Reading of RWrm data from 2nd controller
(256 input points)
Writing of RWwm data in 2nd controller
(256 output points)
Writing of RY data in 2nd controller (8 words)
At the 1st controller, if the input of address 0 is turned on, the output
of address 128 will be turned on.
At the 2nd controller, if the input of address 0 is turned on, the
output of address 256 will be turned on.
Transmission frame check
Transmission frame check
K2
XF X0
H1401
H1405
K4M0
K4M1000
K1
K1
K1
K8
K8
Y0
Y6
TO
TO
FROM H0 HE0
H0 H1
H0 H20
H0 H21
K4M516 K1TO H0 H1E1
K4M1200 K8TO H0 H168
K4M200 K8TOP H0 H160
K4M500 K1TOP H0 H1E0
K4M1700 K16TOP H0 H1F0
H0 HE8FROM
K4M400 K3H0 H2E0FROM
K4M1400 K16H0 H2F0FROM
SET
M530RST
M530
M200
M1700
SET
(Transmission frame check request)
M1214RST
M1214SET