Panasonic SL-VGU1-C

78
Chapter 3
Memory Map
S-LINK V input unit : Change in the input status of address 7 can be judged by reading out the data from bit 7
of I/O data receiving area 00H. If the input status is ON, the bit 7 will be set to ‘1’. If the
input status is OFF, bit 7 will be set to ‘0’.
S-LINK V output unit : To change the output status of address 384, data should be written in bit 0 of I/O data
sending area 10H. If ‘1’ is written, the output status will be set to ON. If ‘0’ is written, the
output status will be set to OFF.
Even if inputs and outputs are assigned non-continuously in the S-LINK V system, the I/O data can
be assigned continuously in the I/O data area of the SL-VGU1-D.
CAUTION
● I/O data sending area
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
00H 135 134 133 132 131 130 129 128
01H 143 142 141 140 139 138 137 136
02H 151 150 149 148 147 146 145 144
03H 159 158 157 156 155 154 153 152
04H 167 166 165 164 163 162 161 160
05H 175 174 173 172 171 170 169 168
06H 183 182 181 180 179 178 177 176
07H 191 190 189 188 187 186 185 184
08H 199 198 197 196 195 194 193 192
09H 207 206 205 204 203 202 201 200
0AH 215 214 213 212 211 210 209 208
0BH 223 222 221 220 219 218 217 216
0CH 231 230 229 228 227 226 225 224
0DH 239 238 237 236 235 234 233 232
0EH 247 246 245 244 243 242 241 240
0FH 255 254 253 252 251 250 249 248
10H 391 390 389 388 387 386 385 384
11H 399 398 397 396 395 394 393 392
12H 407 406 405 404 403 402 401 400
13H 415 414 413 412 411 410 409 408
14H 423 422 421 420 419 418 417 416
15H 431 430 429 428 427 426 425 424
16H 439 438 437 436 435 434 433 432
17H 447 446 445 444 443 442 441 440
18H 455 454 453 452 451 450 449 448
19H 463 462 461 460 459 458 457 456
1AH 471 470 469 468 467 466 465 464
1BH 479 478 477 476 475 474 473 472
1CH 487 486 485 484 483 482 481 480
1DH 495 494 493 492 491 490 489 488
1EH 503 502 501 500 499 498 497 496
1FH 511 510 509 508 507 506 505 504
20H Error cancel
- - - - - - -
21H -
Transmission
frame check
request
- - - - - -