37
QR34642
●Using Remote Controller
Point the remote controller to the infrared receiver
on the DVD Palmcorder. The remote controllable
distance is up to 16 feet (5 m).
Note:Note:
• When using the remote controller, make sure that the
infrared receiver on DVD Palmcorder is not exposed to
direct sunlight or any intense light. If the infrared receiver
is subject to light stronger than the infrared light from
remote controller, the DVD Palmcorder cannot be
operated by remote controller.
• If there is an obstacle between the remote control and
infrared receiver on DVD Palmcorder, remote control may
not be possible.
• The DVD Palmcorder uses the “VCR2” remote control
code of Panasonic VCRs. If you use a Panasonic VCR,
etc. with remote control code set to “VCR2”, a VCR
placed near the DVD Palmcorder will also be operated by
the remote controller: To prevent this, change the remote
control code of the VCR.
10˚
10˚
15˚
15˚
A
p
p
r
o
x
.
1
6
f
e
e
t
(
5
m
)
Infrared
receiver
VDR-M30PP_GB.book Page 37 Friday, March 14, 2003 8:53 PM
To Next Page
Loading...
