18
■ Calling One Site After Another by Sequential Dialing
The control sites can be called one after another to monitor them.
Either enter the quick dial number 000 for sequential dialing, or press the ONE TOUCH DIAL button assigned to quick dial
number 000. This starts sequential dialing to call one site after another.
1
Press the MEMORY button or the DIAL button.
•[■ QUICK DIAL] menu appears on the monitor screen when the QUICK
button is pressed.
•[■ DIAL] menu appears on the monitor screen when the DIAL button is
pressed.
2
Enter the quick dial number 000 by pressing the numeric
buttons and press the ENTER button. Then press the CALL
button. Or press the ONE TOUCH DIAL button assigned to the
quick dial number 000.
•[■ SEQ. DIALING] menu appears on the monitor screen.
Enter 000, then press ENTER button.
d
Quick dial number and title
• Those destinations registered in the directory whose Sequential Dial setting
is ON are called in sequence from the smallest number upward. When the
duration (dwell time) set on the menu has passed, the next destination is
automatically called and displayed the video.
• During communicating with the destination, press the ONE TOUCH DIAL 4
(VIDEO AUTO/MANU) button to release the dwell time for selected video
and continue monitor manually. Pressing that button again will restore the
dwell time for that video and will continue to call the next destination by
Sequential Dialing.
• The starting destination for the dialing can be set on the menu.
• If the destination called by Sequential Dialing is busy or there is no
response, it will be automatically skipped and will call the next destination.
Whether sequential dialing is to
end upon completion of a round of
the sites, or is to be repeated till it
is terminated, can be set using the
setup menu.
Note
To Next Page
Loading...
