Panasonic WJ-AV20

30
000 TOP
100 MODE
↓ (TRANSMITTER)
200 RECEIVING REGI.
↓
300 DIRECTORY/DIALING REGI. ↓
400 SETUP ↓
500 CONTROL ↓
600 MAINTENANCE ↓
700 REMOTE SETUP EDIT ↓
↑↓ :MOVE ENT:SELECT ESC:CLEAR
100 MODE
MODE : TRANSMITTER RECEIVER
←→:SELECT ESC:PRV
1
Move the cursor to item 100 in the TOP menu
by pressing the ▲ or ▼ button, then press the
ENTER button.
The [100 MODE] menu appears on the monitor screen.
2
Select either [TRANSMITTER] or [RECEIVER]
by pressing the t or s button.
TRANSMITTER: When the AV Codec is used at a
remote (destination) site.
RECEIVER: When the AV Codec is used at a control
(local) site.
The factory default setting is TRANSMITTER.
3
Press the ESC button.
After selecting the necessary parameter, press the ESC
button to return to the previous [TOP] menu.
If a setting change is made in the menu, then the dialog
menu for verification appears on the monitor screen.
To change the setting, select [YES] by pressing the t or
s button and then press the ENTER button. (Continue to
process step 4)
To quit the setting change, select [NO] and then press the
ENTER button. The [100 MODE] menu appears again on
the monitor screen.
4
Turn the power off, and then restart the
system by turning the power on.
Tune the AV Codec power off according to the dialog on
the monitor screen. Then turn the AV Codec power on
again.
The system is now in the newly specified setting mode.
First, set the AV Codec operation mode.
d
■CHANGE MODE?
YES NO
←→ :SELECT ENT:EXET ESC:PRV
d
■ POWER OFF THEN POWER ON AGAIN
d
If the mode is changed (for example, from Receiver to Transmitter), the existing setting remains valid. After changing the
mode, be sure to check the setting.
Notes
■ Mode Setup ............................................................................................. [100]
SYSTEM SETUP