Panasonic WJ-AV20

31
000 TOP
100 MODE
↓ (TRANSMITTER)
200 RECEIVING REGI.
↓
300 DIRECTORY/DIALING REGI. ↓
400 SETUP ↓
500 CONTROL ↓
600 MAINTENANCE ↓
700 REMOTE SETUP EDIT ↓
↑↓ :MOVE ENT:SELECT ESC:CLEAR
1
Move the cursor to item 200 in the TOP menu
by pressing the ▲ or ▼ button. Then press
the ENTER button.
The [200 RECEIVING REGI.] menu appears on the monitor
screen.
2
Move the cursor to the desired item by
pressing the ▲ or ▼ button. Then press the
ENTER button.
The selected item submenu appears on the monitor screen.
210: Set a receiving method.
220: Set a local number.
230 Enable or disable calling numbers and called
numbers to be checked
240: Enable or disable a group ID to be checked.
Set the receiving operation method.
200 RECEIVING REGI.
210 RECEIVING REGI.
↓
220 LOCAL NO.REGI. ↓
230 CALLING/CALLED NO.CHECK ↓
240 GROUP ID CHECK ↓
↑↓ :MOVE ENT:SELECT ESC:PRV
210 RECEIVING REGI.
RECEIVING MODE: AUTO MANUAL
RINGER : ON OFF
↑↓ :MOVE ←→:SELECT ESC:PRV
d
● Receiving Method Setup [210]
This item lets you set the receiving mode when calls are
received from the destination.
Move the cursor to the desired item parameter and select the
item mode by pressing the Direction buttons.
• RECEIVING MODE
AUTO: Calls are received automatically.
MANUAL: Calls can be received by pressing the DIAL
button.
The factory default setting is AUTO.
• RINGER
ON: Enables alert tone when a call is received.
OFF: Disables alert tone when a call is received.
The factory default setting is ON.
• The alert tone can be adjusted with the Ringer
Volume Control on the front panel, but cannot be
decreased to zero. If you wish to turn the alert off, set
the parameter to OFF in the RINGER item.
• The alert tone rings twice even in the automatic
receiving mode.
Notes
■ Receiving Registration ....................................................... [200]
Dial-Up Standby