69
Local output
● Camera connections
The camera shall be connected to the video input con-
nectors 1 - 5 on the transmitter side through a coaxial
cable (with BNC plug, to be procured locally). When
our combination camera is used, it shall be connected
to the video input connector 1, without fail.
● Monitor connections
The monitor shall be connected to the monitor connec-
tor 1 or 2, or to the local output connector, through a
coaxial cable (with BNC plug, to be procured locally).
According to the connector used, images to be dis-
played can differ. (See Table below.)
● Sensor connections
The sensor is connected to the SENSOR IN/TRIGGER OUT
connector (Pins 6 - 25) on the transmitter side through the
D-Sub 25-pin connector (male). (See the diagram at right.)
A maximum of 8 sensors can be connected.
Sensors and D-Sub 25-pin connector cables should be
procured separately.
Combination camera is con-
nected to the video input con-
nector 1.
Video input 2 - 5
Monitor 2
Local output
Monitor 1
Connector name
Monitor 1
Menu display
Displayed image
Enabled
Monitor 2 Disabled
Disabled
Standby
During communication
Camera image of own
station (images stored
in the image memory)
Display of camera images of own station always
selected
Display of received
images