1
Press the MENU button.
The TOP menu as shown below appears on the monitor screen.
When the MENU LOCK is set to ON in the setup menu, the INPUT PASS-
WORD menu shown below appears on the monitor screen. Enter the 4-digit
password by pressing the numeric buttons and then pressing the ENTER but-
ton. The TOP menu shown below appears on the monitor screen.
2
To finish the setting process, press the MENU button.
The selected menu is closed and the settings previously made are stored in
the internal memory.
To select an item in the setup menu.
• Move the cursor to the desired item by pressing the ▲ or ▼ button. Then
press the ENTER button to execute the selection.
The selected item or its submenu appears on the monitor screen.
• To return to the previous menu, press the ESC button.
If the ESC button is pressed when the TOP menu is displayed on the mon-
itor screen, then the menu is closed.
• An item can also be selected with the numeric buttons apart from selec-
tions with the Direction and ENTER buttons.
If a menu number is entered, starting with the most significant digit in
selecting the item by pressing the Numeric buttons, then the menus of
succeeding numbers appear on the monitor screen as shown in the exam-
ple below.
↓ indicates there is a submenu.
Do not switch the power off while a
menu is displayed on the screen.
The settings are stored in the inter-
nal memory (flash memory) when
the menu is closed. If the power is
switched off while a menu is dis-
played on the screen, the settings
will not be stored. There is also the
danger of destroying the data
stored in the internal memory.
Note
[000 TOP] menu
d
To [400 SETUP] menu
To [420 SERIAL/HOST PORT] menu
Press [4].
g
To [421 SERIAL DATA PORT] menu
Operation guide
Press ESC button.
d
Press [2].
g
Press ESC button.
d
Press [1].
g
Press ESC button.
To Next Page
Loading...
