6
Press the # (ALM MEMORY) button at the control site to
request an alarm video from the remote site.
!0
i
y
o
u
10
Press the ENTER button to select video reproduction.
The AV Codec will start reproducing the Select [YES} and you can press
the ENTER button to play back the alarm video previously stored in the
internal memory.
After the playback is completed, the AV Codec returns to a standby state.
7
Select [YES] by pressing the direction button, then press the
ENTER button.
• The AV Codec at the remote site temporarily interrupts the real-time video
and audio transmission and begins to transmit an alarm video.
• The dialog appears on the monitor at the control site, and the video imme-
diately preceding the transfer is displayed as a still.
Audio and data transmission will be also interrupted.
• It takes about 150 seconds to transfer an alarm video (40 seconds at 128
kbps (2B)).
• After the transfer, real-time video at the remote site is displayed on the
monitor at the control site.
8
Press the DIAL button for 2 seconds or more to terminate
communication.
The alarm video cannot be played back during communication.
Terminate communication before attempting to play back the alarm video.
9
Press the # (ALM MEMORY) button at the control site button.
The dialog shown below appears on the monitor in the control site.
To Next Page
Loading...
