#001 UNASSIGNED NUMBER Dialing number is not currently assigned (allocated). Confirm dialing num-
ber. If it’s correct, then ask your telecom service agent or the sales agent of
our service people.
#002 NO ROUTE No route to specifies the transit network.
Ask your telecom service agent or the sales agent of our service people.
#003 NO ROUTE No route to the destination.
Ask your telecom service agent or the sales agent of our service people.
#006 CHANNEL UNACCEPTABLE The channel most recently identified is not acceptable to the sending entity
for use in this call.
Try to dial again. If impossible, ask your telecom service agent or the sales
agent of our service people.
#007 CHANNEL UNACCEPTABLE Call delivered to an established channel.
Try to dial again. If impossible, ask your telecom service agent or the sales
agent of our service people.
#016 NORMAL DISCONNECTION Usually this information appears upon disconnection.
#017 USER BUSY The called user is busy.
Try to dial again.
#018 NO USER RESPONDING The user does not respond to receiving calls because the ISDN line cable is
not connected or power is off.
Confirm the connection between WJ-AV20 and the network and check the
power.
#019 NO ANSWER FROM USER The user does not respond to receiving calls.
Confirm the MANUAL setting of [210 RECEIVING REGI.].Menu at the remote
WJ-AV20.
#021 CALL REJECTED The remote user rejected the receiving call.
Confirm remote user.
#022 NUMBER CHANGED Dialing number has already changed.
Confirm dialing number. If it’s correct, ask your telecom service agent or the
sales agent of our service people.
#026 NON SELECTED USER The user has not been awarded the incoming call when the bus connection
is made.
To receive a call and communicate, register the local sub-address number
in [220 LOCAL NO.REGI.].
#027 REMOTE OUT OF ORDER The user does not respond to receiving calls because the ISDN line cable is
not connected or power is off.
Confirm the connection between WJ-AV20 and the network and check the
power.
#028 INVALID NUMBER Dialing number is not valid. Confirm dialing number.
If it’s correct, ask your telecom service agent or the sales agent of our ser-
vice people.
#029 FACILITY REJECTED A facility requested by the user can not be provided by the network. Ask the
sales agent of our service people.
#031 NORMAL DISCONNECTION Usually this information appears on disconnection.
#034 NO CHANNEL AVAILABLE The called user is busy. Try to dial again.
#038 NETWORK OUT OF ORDER The network is not functioning correctly and this condition is likely to last a
relatively long period of time. Ask your telecom service agent or the sales
agent of our service people.
#041 TEMPORARY FAILURE The network is not functioning correctly and this condition is not likely to last
a long period of time. Ask your telecom service agent or the sales agent of
our service people.
#042 SWITCH CONGESTION The switching equipment is experiencing a period of high traffic. Try to dial
later.
Ask your telecom service agent or the sales agent of our service people.
#199 (No display) ISDN line cable is not connected.
Confirm the connection between the WJ-AV20 and the network.
#255 (No display) The configurations at the network or PBX have changed.
Please power off and on for WJ-AV20.
80
Code Monitor Display
■ Cause Value on Dialing Failure or Line Terminated
To Next Page
Loading...
