Panasonic WV-SP300 Series

37
Configure the settings relating to the logs [Log]
Click the [Log] tab on the "Basic" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to the log list can be configured in this section.
■ Alarm
Settings for the alarm log list can be performed.
[Save logs]
Select"On"or"Off"todeterminewhethertosavethe
alarm logs.
On: Alarm logs will be saved.
Off: Alarm logs will not be saved.
Default:On
[Name of the destination directory for downloaded
images]
Enter the name of the destination directory to which
images associated with the logs are to be downloaded.
Forexample,enter"C:\alarm"todesignatethefolder
"alarm" under drive C.
Available number of characters: 3 - 128 characters
Available characters: Alphanumeric characters, the
slash(/),thebackslash(\),thecolon(:)andthe
underscore (_).
■ Manual
Configure the settings relating to manual saving of the
log list.
Select"On"or"Off"anddesignatethedestination
folder in the same manner as for "Alarm".
■ FTP error
Perform the settings for the FTP error log list.
Select"On"or"Off"anddesignatethedestination
folder in the same manner as for "Alarm".
Important:
 • When"Namew/otime&date"isselectedfor"File
name" on the [FTP img. trans.] tab on the "Network"
page, FTP error log and associated images will not
be saved.
  Tosavethem,select"Namew/time&date".(☞ Page
83)
Note:
 • When"H.264"isselectedfor"Recordingformat",
"FTP error" is unavailable.