Panasonic WV-SP300 Series

68
Configure the settings relating to Panasonic alarm protocol [Notification]
Click the [Notification] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to Panasonic alarm protocol can be configured in this section.
■ Panasonic alarm protocol notification
[Panasonic alarm protocol]
Select"On"or"Off"todeterminewhetherornottopro-
vide notification by Panasonic alarm protocol according
tothesettingsforthe"Alarm"and"Diag."checkboxes
of "Destination of notification" below.
 • Whenanalarmisdetected("Alarm")
 • Whenanotificationoftheremainingcapacityofthe
SD memory card has been provided ("Diag.")
 • WhentheSDmemorycardhasbecomefull("Diag.")
 • WhentheSDmemorycardcannotberecognized
("Diag.")
Default:Off
Note:
 • When"On"isselected,notificationofthealarm
occurrence will be provided to the registered desti-
nation addresses in order (to IP address 1 first, to IP
address 8 last).
[Destination port]
Select a destination port for the Panasonic alarm proto-
col from the following.
Available range: 1-65535
Default: 1818
[Retry times]
Select a retry time for the Panasonic alarm protocol.
Available range: 0 - 30
Default: 2
■ Destination of notification
[Address 1] - [Address 8]
Enter the destination IP address of the Panasonic alarm
protocol from the following. Host name is unavailable
for the IP address. Up to 8 destination addresses can
be registered.
"Alarm" checkbox:Whenthecheckboxischecked,
the Panasonic alarm notification will be provided
upon an alarm occurrence.
"Diag." checkbox:Whenthecheckboxischecked,
notification using Panasonic alarm protocol will be
provided in the following cases.
 • Whennotificationoftheremainingcapacityof
the SD memory card has been provided
 • WhentheSDmemorycardhasbecomefull
 • TheSDmemorycardcannotberecognized
"Destination IP address": Enter the destination
address.
To delete the registered IP address, click the [Delete]
button respective to the desired IP address.
Important:
 • ConfirmthatthedestinationIPaddressesareregis-
tered correctly. When a registered destination does
notexist,notificationmaybedelayed.