Panasonic WV-SP300 Series

82
Configure the settings relating to SNMP [SNMP]
Click the [SNMP] tab on the "Network" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to SNMP can be configured on this page. It is possible to check the status of the camera by
connecting to the SNMP manager. When using the SNMP function, contact the network administrator.
[Community]
Enter the community name to be monitored.
Available number of characters: 0 - 32 characters
Default: None (blank)
Important:
 • WhenusingtheSNMPfunction,itisnecessaryto
enter the community name. When no community
name is entered, the SNMP function will not work.
[System name]
Enter a system name to be used to manage the camera
with the SNMP function.
Available number of characters: 0 - 32 characters
Default: None (blank)
[Location]
Enter the name of the location where the camera is
installed.
Available number of characters: 0 - 32 characters
Default: None (blank)
[Contact]
Enter the mail address or the phone number of the
SNMP manager.
Available number of characters: 0 - 255 characters
Default: None (blank)