Panasonic WV-SP300 Series

67
Configure the settings relating to the mail notification [Notification]
Click the [Notification] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail server
to perform the mail notification. (☞ Page 75)
■ Mail notification
[Mail server >>]
When"Mailserver>>"isclicked,the[Mail]tabofthe
"Server" page will be displayed. (☞ Page 75)
[Mail notification]
Select"On"or"Off"todeterminewhetherornottopro-
vide notification by e-mail according to the settings for
the"Alarm"and"Diag."checkboxesof"Destinationof
notification" below.
 • Whenanalarmisdetected("Alarm")
 • Whenanotificationoftheremainingcapacityofthe
SD memory card has been provided ("Diag.")
 • WhentheSDmemorycardhasbecomefull("Diag.")
 • WhentheSDmemorycardcannotberecognized
("Diag.")
Default:Off
[Alarm image attachment]
Select"On"or"Off"todeterminewhetherornotto
attach an image to the mail to be sent when an alarm is
detected.
Default:Off
Note:
 • Thesettingsfor"Imagecapturesize"ofthe"Alarm
image" section on the [Alarm] tab (☞ page 61) will
be applied to the size of the image to be attached.
■ Destination of notification
[Address 1] - [Address 4]
Enter the destination mail address. Up to 4 destination
addresses can be registered.
"Alarm" checkbox:Whenthecheckboxischecked,
the mail notification will be performed upon an
alarm occurrence.
"Diag." checkbox:Whenthecheckboxischecked,the
mail notification will be provided in the following
cases.
 • Whennotificationoftheremainingcapacityof
the SD memory card has been provided
 • WhentheSDmemorycardhasbecomefull
 • TheSDmemorycardcannotberecognized
"Destination address": Enter the destination address.
To delete the registered address, click the [Delete] but-
ton respective to the desired address.
Available number of characters: 3 - 128 characters
[Mail subject]
Enter the mail subject.
Available number of characters: 0 - 50 characters
[Mail body]
Enter the mail body.
Available number of characters: 0 - 200 characters
Note:
When the SD memory card becomes full, notifica-
tion mail will be sent with the following message.
 • WhentheSDmemorycardhasbecomefull:
"The SD memory card is full."
 • WhenmountingoftheSDmemorycardfailed:
"The SD memory card cannot be recognized."