Panasonic WV-SP300 Series

66
■ VMD information addition
[Information addition]
Select"On"or"Off"todeterminewhetherornottoadd
VMD information to image data.
The VMD information can be searched by Panasonic
network disk recorders (WJ-ND400 series). Refer to the
operating instructions of the connected devices for fur-
ther information about the functions and settings.
Default:Off
Set the VMD areas
Important:
 • Whenthesettingsarebeingconfiguredonthesetupmenu,sometimestheVMDfunctionmaynotworkcor-
rectly.
Step 1
Set the video motion detection area by dragging the
mouse on the screen.
→ The designated area will become the VMD area
"1(White)" and the outline will be displayed. When 2
- 4 VMD areas are set, each area will be numbered
in order. The areas will be identified by the respec-
tive outline colors. The "Status" of the outline to be
setfortheareawillbecome"On".
Step 2
Adjust "Detection area" and "Detection sensitivity"
using the slide bar. Refer to page 65 for further informa-
tion about the "Detection sensitivity" and "Detection
area".
The currently displayed area and its detection sensitiv-
ity will be displayed in the "Detection area" section.
Change areas and the settings of "Detection area" and
"Detection sensitivity" as necessary.
Step 3
Click the [Set] button after completing the settings.
Important:
 • Thesettingwillnotbeappliedunlessthe[Set]but-
ton is clicked.
Step 4
To invalidate the VMD area, click the [Set] button after
selecting"Off"for"Status"oftheVMDareatobeinvali-
dated.
→ The outline of the invalidated VMD area will turn to a
dotted line. When the VMD area is invalidated, no
alarm will occur even when a motion can be recog-
nized in the area.
Step 5
To delete the VMD area, click the [Delete] button corre-
sponding to the area to be deleted.
→ The outline of the respective VMD area will disap-
pear.
Step 6
Click the [Set] button.
→ The edited settings will be applied.