Panasonic WV-SP300 Series

46
Configure the settings relating to MPEG-4 images [JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Image/Audio" page. (☞ Pages 22 and 23: How to display/operate the setup
menu)
The [JPEG/MPEG-4] tab will be displayed when "MPEG-4" is selected for "Video encoding format". (☞ Page 42)
ConfigurethesettingsrelatingtoMPEG-4imagesuchas"Maxbitrate(perclient)*","Imagecapturesize","Image
quality", etc. in this section.
Refer to page 42 and 41 for the settings relating to H.264 images and JPEG images respectively.
■ MPEG-4(1) · MPEG-4(2)
[MPEG-4 transmission]
Select"On"or"Off"todeterminewhetherornotto
transmit MPEG-4 images.
On: Transmits MPEG-4 images.
Off: Does not transmit MPEG-4 images.
Default:On
Important:
 • When"16:9"isselectedfor"Aspectratio",MPEG-4
transmission is unavailable.
 • When"H.264"isselectedfor"Recordingformat",
MPEG-4 transmission is unavailable.
Note:
 • When"On"isselectedfor"MPEG-4transmission"
in "MPEG-4 (1)", displaying of both MPEG-4 images
and JPEG images on the "Live" page will become
available.
 • When"On"isselectedfor"MPEG-4transmission"
in "MPEG-4(1)" and "MPEG-4(2)", MPEG-4 images
are viewable using other devices with each setting.
 • When"On"isselectedfor"MPEG-4transmission"
in "MPEG-4(1)" or "MPEG-4(2)", the transmission
interval of JPEG images may sometimes become
longer.
[Internet mode (over HTTP)]
Select"On"whentransmittingMPEG-4imagesviathe
Internet. It is possible to transmit MPEG-4 images with-
out changing the broadband router settings configured
for JPEG image transmission.
On: MPEG-4 images and audio will be transmitted
using the HTTP port. Refer to page 79 for further
information about the HTTP port number settings.
Off: MPEG-4 images and audio will be transmitted
using the UDP port.
Default:Off