Panasonic WV-SP300 Series

65
[Area]
When selecting a VMD area in the screen, it will be
numbered as area 1. (Subsequent areas will be num-
bered in the order of selection.)
[Status]
Select"On"or"Off"todeterminewhetherornotto
activate each VMD area.
On: Activates the respective VMD area.
Off: Inactivates the respective VMD area.
Default:Off
[Detection area]
Adjust the size of the VMD area using the slider. The
smaller the selected value is, the higher the sensitivity
of VMD area becomes. The current value (1-10) will be
displayed on the right of the slider.
Default: 1
[Detection sensitivity]
Adjust the sensitivity of motion detection in the VMD
area using the slider. The settings can be configured for
each area individually. The larger the value is set, the
higher the sensitivity level becomes.
The current value (1 (low) - 15 (high)) will be displayed
below the slider.
Default: 8
[Delete] button
Click the [Delete] button corresponding to the area to
be deleted. The outline of the selected area will be
deleted.
[Light detection control]
Select"On"or"Off"todeterminewhetherornotto
detect video motion affected by brightness change
such by a dimming level control.
Default:Off
Important:
 • "Lightdetectioncontrol"maynotworkwhenbright-
ness change is too small.
 • When"On"isselectedfor"Lightdetectioncontrol",
the video motion detection may sometimes not be
performed even when detecting a subject moving
over the whole screen.
Set the VMD areas [VMD area]
Click the [VMD area] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
Important:
 • Thealarmoccurrenceindicationbutton(☞ page 9) will be displayed when motion is detected by the VMD func-
tion.
 • Thealarmoccurrenceindicationbuttonwillbedisplayedwhenreceivinganalarminputofaterminalalarmora
command alarm.
 • Dependingonthenetworkenvironment,notificationmaybedelayedevenwhen"Realtime"isselectedfor
"Alarm status update mode" on the [Basic] tab of the "Basic" page (☞ page 27).
 • Themotiondetectionfunctionisnotthededicatedfunctiontopreventthefts,fires,etc.Wearenotresponsible
for any accidents or damages occurring in case.