Parker IPA-15HC - X1 Output Power Connector

ELECTRICAL INSTALLATION
28 IPA Hardware Installation Guide
X1 – Output Power Connector
The drive’s Motor screw terminal connector provides output power to the motor. For connection information,
see “Output (Motor) Power” on page 42.
The drive’s Motor connector provides terminals U, V, W and for connecting output power to the motor. It
also serves to connect an external motor brake to the drive’s internal solid-state relay on the two BK terminals.
This connector is removable.
Motor Screw Terminal Connector Specifications
Description
Specification
Connector Type
Removable screw terminal
Terminals
6
Pitch
0.200 in (5.08 mm)
Wire range
12-26 AWG
14-27 SWG
(0.12-3.30 mm
2
)
Wire strip length
0.310 in (8 mm)
Torque
7.0 in–lbs nom. (0.79 N-m)
Figure 5. - Output Power Connector