Parker IPA-15HC - Ethernet Connector Pinout and LEDs; Assigning IP Addresses for IPA

TROUBLESHOOTING
56 IPA Hardware Installation Guide
Ethernet Connector Pinout
The following table contains the Ethernet connector pinout.
RJ-45 Connector Pinout
Signal
Pin
Wire Color
Description
RX+
1
White with orange
Differential Receive positive side
RX-
2
Orange
Differential Receive negative side
TX+
3
White with green
Differential Transmit positive side
4
Blue
Not used
5
White with blue
Not used
TX-
6
Green
Differential Transmit negative side
7
White with brown
Not used
8
Brown
Not used
Note: Pin assignment follows EIA/TIA T568B guidelines.
RJ-45 LED Ethernet Status Indicators
LEDs located on the RJ-45 socket connector indicate Ethernet status. The next table describes the LED states and
their meanings.
RJ-45 Ethernet Status LED Indications
Signal
Steady
Flash
Description
Ethernet
Link/Activity
Off
—
No Ethernet link
detected
Yellow
—
Ethernet link established,
no activity
—
Yellow
Ethernet link established
and active
Ethernet
Speed
Off
—
Ethernet 10Mbps
Green
—
Ethernet 100Mbps
Assigning IP Addresses
Communication between the IPA and your PC must be set up before connecting over the Ethernet network. Do
this by first setting the IP address of the IPA, and then setting the IP address and subnet mask for the PC.
Setting the IP Address— IPA
The factory assigns the following to each IPA:
IP Address
Subnet Mask (fixed)
192.168.100.01
255.255.255.0