Flat Bed Foil Printer User Guide
Peleman Industries
New machines from June 2019 will receive new position sensors. This will result in a
different behaviour comparing to previous version.
Main advantage is correct print position after each print and power cycle.
5.3 Software Installation
Visit the website: https://webshop.peleman.com/en-be/machine/unifoilprinter or
https://flatbedfoilprinter.com/ to download the installation package or install the package
from the supplied USB drive.
Make sure you use the software version compatible with your firmware. Please refer to the
compatibility table in the software specification section.
In Downloads you will find software version(s) for download and installation. Download the
.zip file and unpack the folder or use supplied USB drive to get the installation files.
The installation media includes 2 files (as shown in figure 12), which are required for the
successful installation of the Flat Bed Foil Printer PC Tool. Please contact your local
distributor or dealer if you encounter any difficulties in finding these files.
Figure 12: Files Required for Installation
To install the Flat Bed Foil Printer PC Tool, open the folder where these two files are located
and start setup.exe to install the software application and the associated drivers. Follow the
installation steps to perform the installation.
Please pay attention to:
-Licence agreement
-Installation folder
-Shortcuts
-Driver installation
To Next Page
Loading...