EasyManuals Logo

Pentax K20D User Manual

Pentax K20D
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
130
Shooting Functions
4
2
Set the step interval.
Turn the rear e-dial while pressing
the ] button. The available
bracketing amounts in [2. EV Steps]
in the [A Custom Setting] menu
(p.73) are as follows.
3
Press the shutter release button halfway.
The focus indicator ] appears in the viewfinder when focused.
4
Press the shutter release button fully.
Three continuous pictures will be taken, the first with no compensation,
the second with negative compensation, and the third with positive
compensation (when the number of frames is set to [3]).
Bracketing amount
(Step interval)
1/2 EV ±0.5, ±1.0, ±1.5, ±2.0
1/3 EV ±0.3, ±0.7, ±1.0, ±1.3, ±1.7, ±2.0
• When the focus mode is set to l (Single mode), the focus is locked in the
first frame position and used for subsequent continuous frames.
• When you release your finger from the shutter release button during Auto
Bracket, the Auto Bracket exposure setting will remain effective for twice as
much time as the exposure metering timer (default setting is 20 seconds)
(p.99) and you can take a picture at the next compensation value. In this
case, auto focusing works for each frame. After about twice as much time as
the exposure metering timer (default setting is 20 seconds), the camera
returns to settings for taking the first picture.
• You can combine Auto Bracket with the built-in flash or external flash (P-TTL
auto only) to change only the flash output continuously. However, when using
an external flash, holding the shutter release button down to take three
continuous frames may cause the second and third frame to be taken before
the flash is fully recharged. Always take one frame at a time after confirming
that charging is complete.
• Exposure Bracket is not available when the exposure mode is set to p (Bulb)
mode.
• Exposure Bracket and Multi-exposure cannot be used together. The mode
set last is used.
• When [8. One-Push Bracketing] in the [A Custom Setting] menu is set to
[On], even if the shutter release button is not continuously pressed fully, all
frames are automatically shot with one press of the shutter release button.

Table of Contents

Other manuals for Pentax K20D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pentax K20D and is the answer not in the manual?

Pentax K20D Specifications

General IconGeneral
Camera TypeDigital SLR
Sensor TypeCMOS
Sensor Size23.4 x 15.6 mm
Resolution14.6 MP
Continuous Shooting Speed3 fps
Image StabilizationSensor-shift
Screen Size2.7 inches
Screen Resolution230, 000 dots
Storage MediaSD/SDHC
Dimensions141.5 x 101 x 70 mm
Weather SealingYes
Image ProcessorPRIME (Pentax Real Image Engine)
Shutter Speed30-1/4000 sec
ViewfinderOptical (pentaprism)
BatteryRechargeable Lithium-Ion battery
ISO RangeISO 100 - 3200 (expandable to 6400)

Related product manuals