126
Shooting Settings
5
2
Under the light you wish to measure the white balance of,
fully display a white sheet of paper on the monitor, or
select a white area as the subject.
3
Press the shutter release button fully.
Set [Focus Method] to \ when the shutter cannot be released.
Adjust the white balance as necessary. (p.127)
4
Press the 4 button.
The camera is ready to take a picture.
• No image is recorded when the shutter release button is pressed to adjust
the white balance.
• The message [The operation could not be completed correctly] appears
when measuring is unsuccessful. Press the 4 button while displayed to
remeasure the white balance.
• If a picture is extremely overexposed or underexposed, the white balance
may not be adjusted. In this case, adjust exposure to the correct exposure
before adjusting the white balance.
To Next Page
Loading...
