Pentax Q User Manual

59
Basic Operations
3
1 Press the four-way controller (3) in Step 2 on p.58.
2 Turn the e-dial.
The flash compensation value is
displayed.
Press the d/i button to reset the value
to 0.0. (Available only when [Green
Button] is assigned to the d/i button in
[Green Button] of the [A Rec. Mode 3]
menu (p.144).)
1 Select a flash mode.
2 Slide the flash pop-up switch in
the direction of the arrow.
The built-in flash pops up.
3 Press the shutter release button halfway.
The flash starts charging.
4 Press the shutter release button fully.
The picture is taken.
• When the flash output exceeds its maximum amount, the compensation will
not be effective even if the compensation value is set to the plus (+) side.
• Compensating to the minus (-) side may have no effect if the subject is too
close, the aperture is set to a large opening, or sensitivity is high.
• The flash output compensation is also effective for external flash units which
support P-TTL auto flash mode.
Shooting with the Flash
Auto Flash Discharge
Auto Flash Discharge
+0.7
+0.7
Cancel
Cancel
OK
OK
OK
MENU

Pentax Q Specifications

General

Category	Digital Camera
Type	Mirrorless
Sensor Type	CMOS
Sensor Size	1/2.3 inch
Effective Pixels	12.4 MP
Lens Mount	Pentax Q-mount
LCD Screen Resolution	460, 000 dots
Continuous Shooting	5 fps
Video Recording Frame Rate	30 fps
Storage Type	SD/SDHC/SDXC
Dimensions	98 x 57.5 x 31 mm
ISO Sensitivity	125-6400
LCD Screen Size	3.0 inches
Shutter Speed	1/2000 - 30 sec
Video Resolution	1920 x 1080
Battery Type	D-LI68
Weight	200 g (including battery)