100 KENR6933
Troubleshooting Section
Table 35
Trip Points for the Engine Coolant Temperature
E361-1 E361-2 E361-3
Trip Point
113°C(233°F) 114°C(237°F) 118°C(244°F)
Delay to Activation 10 seconds 10 seconds 2 seconds
Reset Time 4 seconds 20 seconds 20 seconds
System Response:
The event code will be logged.
Theoptionalwarninglampwillbeilluminated.
Possible Performance E ffect:
E361-1
None
E361-2
The ECM will derate the power. The power will be
derated at one percent per second.
The derate of the engine will only occur if the “Enable
Derate” customer programmable parameter has
been enabled.
E361-3
[The ECM will shut down the engine after two
seconds when the trip point for the engine coolant
temperature has been reached.
The shutdown of the engine will only occur if
the “Enable Shutdown” customer programmable
parameter has been enabled.
Troubleshooting:
Refer to Troubleshooting, “Coolant Temperature Is
Too High”.
Results:
•
OK – STOP.
i02536618
E362 Eng ine Overspeed
Conditions Which G enerate This Code:
The engine speed is above 3000 RPM for more than
0.6 seconds.
Note: This event code represents an event. This
does not represent an electronic system fault.
System Response:
The event code will be logged.
The optional warning lamp will be illuminated.
Theeventmaybeviewedbyusingadisplaymodule
or by using the Perkins Electronic Service Tool (EST).
The ECM will reset the event when the engine speed
is lower than 2800 RPM for 0.6 seconds.
The fuel injection will be disabled until the event has
been reset.
Possible Performance Effect:
E362-1
None
Troubleshooting:
This event indicates excessive engine speed. This
event does not represent a problem with the Engine
Control Module (ECM).
This event does not represent a problem with the
Electronic Speed/Timing Sensor.
The ECM logs the event.
No troubleshooting is required.
Results:
•
OK – STOP.
To Next Page
Loading...
