Perkins 1106C - CID 0003 Fmi 05; CID 0003 Fmi 06

76 KENR6933
Troubleshooting Section
•
Data from the electronic unit injector for the No. 3
cylinder is out
of limits.
•
Diagnostic code 0168-01 is not active.
•
Diagnostic codes 0001-05 and 0001-06 are not
active.
•
No 0041 diagnostic codes are active.
•
No 0262 diagno
stic codes a re active.
•
Diagnostic code 0190-08 is not active.
•
No 0110 diagnostic codes are active.
System Respon
se:
If equipped, the warning light will come on. An active
diagnostic co
de will be generated. The ECM will log
the diagnostic code.
Possible Per
formance Effect:
The engine will be derated while this diagnostic code
is active.
Troubleshooting:
Perform the following diagnostic procedure: “Injector
Data Incorrect - Test”
Results:
•
OK – STOP.
i02748636
CID 0003 FMI 0
5
Conditions Which G enerate This Code:
This diagnos
tic code is designed to indicate an open
circuit (low current) in either the solenoid or the wiring
for the electronic unit injector for No. 3 cylinder.
The Electronic Control Module (ECM) detects the
following condition:
•
A low current condition (open circuit) for each of
five consecutive attempts to operate
•
Battery voltage is higher than 9 volts for 2 seconds.
System Resp
onse:
If equipped, the warning light will come on. The ECM
will log the
diagnostic code.
Possible Performance Effect:
The engine will have low power and/or rough running.
Troubleshooti
ng:
When an injector cutout test is performed, a faulty
electronic un
it injector will indicate a low reading in
comparison with the other electronic unit injectors.
An electrical
fault can prevent the electronic unit
injector from operating. An open circuit in the wiring
that is unique to the electronic unit injector will prevent
that individ
ual electronic unit injector from operating.
An open circuit in common wiring within the ECM can
prevent the three electronic unit injectors that share
that common w
iring from operating.
The ECM will continue to attempt to operate the
electronic u
nit injector after the diagnostic code has
been logged but an open circuit will prevent the
operation of the electronic unit injector.
Perform the following diagnostic procedure: “Injector
Solenoid Circuit - Test”
Results:
•
OK – STOP.
i02748639
CID 0003 FMI
06
Conditions Which Generate This Code:
This diagno
stic code is designed to indicate a short
circuit (high current) in either the solenoid or the
wiring for the electronic unit injector for No. 3 cylinder.
The Electronic Control Module (ECM) detects the
following conditions:
•
A high current condition (short circuit) for each of
five consecutive attempts to operate
•
Battery voltage above 9 volts for 2 seconds
System Res
ponse:
If equipped, the warning light will come on. The ECM
will log th
e diagnostic code.
Possible Performance Effect:
The engine will have low power and/or rough running.