Perkins 1106C - E361 High Engine Coolant Temperature

KENR6933 99
Troubleshooting Section
g01269384
Illustration 17
Level 3 engine oil pressure versus engine speed
System Response:
360-1
The warning lamp will flash while the warning is
active.
The Electronic Control Module (ECM) will generate a
46 flash code that will be displayed via the diagnostic
lamp.
The ECM will generate a E360-1 event code.
The ECM will generate a SPN 100-FMI 17 event
code on the J1939 data link. The event code may be
displayed on a receiving device on the J1939 data
link.
360-2
The warning lamp will flash while the derate is active.
The ECM will generate a 46 flash code that will be
displayed via the diagnostic lamp.
The ECM will generate a E360-2 event code.
The electronic service tool will display “Engine
Derate” in the first “Engine Status” box on any status
screen.
The ECM will generate a SPN 100-FMI 18 event
code on the J1939 data link. The event code may be
displayed on a receiving device on the J1939 data
link.
360-3
The warning lamp will flash.
The ECM will generate a 46 flash code that will be
displayed via t
he diagnostic lamp.
The ECM will generate a E360-3 event code.
The ECM will generate a SPN 100-FMI 01 event
code on the J1939 data link. The event code may be
displayed on a
receiving device on the J1939 data
link.
Possible Perf
ormance Effect:
360-1
Engine operation is not affected.
360-2
The ECM will derate power by 17.0 percent per
second up to a m
aximum of 100 percent while the
derate is active.
360-3
The engine will shut down.
Troubleshooting:
Refer to Trou
bleshooting, “Low Engine Oil Pressure”.
Results:
•
OK – STOP.
i02655566
E361 High Engine Coolant
Temperature
Conditions
Which Generate This Code:
The Electronic Control Module (ECM) detects a
fault with t
he engine coolant temperature. The ECM
detects the following faults:
•
Theengineh
as been running for more than 185
seconds.
•
The trip poi
nt for the event code for the temperature
of the engine coolant is reached.
•
Diagnostic
code 0110-03 Engine Coolant
Temperature open/short to +batt is not active.
•
Diagnosti
c code 0110-04 Engine Coolant
Temperature short to ground is not active.
•
Diagnosti
c code 0168-01 Electrical System voltage
low is not active.