Perkins 1106C - Troubleshooting With Event Codes

KENR6933 97
Troubleshooting Section
Troubleshooti
ng with an
Event Code
i02411237
Event Codes
The ECM can log events. Events refer to engine
operating con
ditions such as low oil pressure or high
coolant temperature. Logged events usually indicate
a mechanical problem instead of an electronic
system probl
em.
Note: If a diagnostic code has already been logged
then any asso
ciated event code to that fault will not
be logged as well.
i02539780
E172 High Air Filter R estriction
Conditions Which G enerate This Code:
This event code will only be generated if the switch for
the air filter restriction is installed and the customer
programmable feature is enabled.
The Electronic Control Module (ECM) detects a
problem with the air fl ow. If the air flow has been
restricted for more than thirty seconds, the ECM will
generate this code.
Note: This code is generated only when the engine is
running. This event code will become inactive when
the restriction decreases for more than 5 seconds.
System Response:
The event code will be logged.
Theoptionalwarninglampwillbeilluminated.
Possible Performance E ffect:
E172-1
A blocked filter may cause the engine to experience
symptoms such as low power.
Troubleshooting:
The event code may represent a problem with
the electronic system. This event code normally
indicates high air filter restriction. Refer to Testing
and Adjusting Manual, “Air Inlet and Exhaust System
- Inspect”.
Results:
•
OK – STOP.
i02536030
E232 High Fuel/Water
Separator Water Level
Conditions Wh
ich Generate This Code:
This event code will only be generated if the switch
on the water se
parator filter is installed and correctly
wired to the ECM and the customer programmable
feature is enabled.
The Electronic Control Module (ECM) detects a
problem with the water level in the fuel filter. A water
level sensor
may be installed in the fuel filter.Ifthe
water rises above a set level for more than thirty
seconds, the ECM will generate this code. The code
will become
inactive when the switch has been
immersed in fuel for 5 seconds.
Note: The co
de is generated only when the engine
is running.
System Resp
onse:
The event code will be logged.
The optional warning lamp will be illuminated.
Possible Pe
rformance Effect:
E232-1
None
Troublesho
oting:
Refer to Testing and Adjusting manual, “Fuel System
- Inspect”.
Results:
•
OK – STOP.
i02536616
E360 L ow Engin e Oil Pressure
Conditions Which Generate This Code:
The following conditions occur:
360-1