• The engine will remain at this speed while the
diagnostic code remains active.
• All inputs from the faulty throttle are ignored by the
ECM until the fault is repaired.
• All inputs from the repaired throttle will be ignored
by the ECM until the keyswitch has been cycled.
The IVS may be installed. The IVS is required for
mobile applications with an analog throttle installed.
The IVS is part of the throttle position sensor. The
IVS is CLOSED when the low idle is set.
The configuration parameters for the throttle and for
the IVS thresholds are programmed into the ECM.
Use the electronic service tool in order to display the
configuration parameters for the throttle and for the
IVS.
If the IVS operates outside of the programmed range,
then the engine speed may not respond to changes
in the throttle position.
The electronic service tool may be used for the
following:
• If necessary, reset the IVS threshold for an
existing IVS.
• If necessary, view the IVS change point and reset
the IVS thresholds when a new throttle assembly
is installed.
UENR4469-36 335
Circuit Tests
Copyright of Perkins Engine Company Limited. NOT FOR REPRINTING OR RESALE
To Next Page
Loading...
