Perma PRO 500 - Mounting and Assembly for PRO C; 4.1 Wall Mounting the Drive Unit

permaPROC-8-
4. Assembly and Mounting of the Lubrication System
4.1 Mounting the Drive Unit onto a Fixing Device for Wall-Mounting
♦ Attachthesuppliedmountingdevicetothedriveunitusingthetwoenclosedhexheadbolts(M6x16)and
thetwowashers.
♦ Screwthemountingdevicewiththedriveunitontoasupportofyoursystem.Theboringtemplateofthethree
mountingscrews(141.5x45)canbeseenbelowingure3oronthetemplatethatisincluded.Youhaveto
useatleastthreehexagonscrewsM6x25(e.g.onmetalground).
♦ Beforeyouconnecttheoutletofthedriveunittothelubricanttube,youhavetomakesurethatthelubrication
pointsandthecompletelubricanttubeispre-lubricatedwiththesamelubricantthatiscontainedinthePRO
LCunit.Forthat,perma-tecoffersa400glubricationcartridgeformanually-operatedgreasepresseswiththe
requestedlubricant.
♦ Connectthelubricanttube(connectionG3/8)totheoutletofthedriveunitandinstallthetubecorrectly
betweentheoutletandthelubricationpoint.Thelubricanttubemustnotbelongerthanvemeters.
Make sure that you assemble the connections and lubricant tubes correctly and tightly to avoid possible
leakage.
gure3
2hexheadbolts
M6x16,maximum
torque3Nm
(supplied
forattachingthe
permaPROCtothe
mountingdevice)
Hexagonscrew
M6x25(forwall
mountingonmetal)
2hexagonscrews
M6x25(forwall
mountingonmetal)
143
45
141,5