Perma PRO 500 - Combination of Distributor and Lubricator; 4.3 Combination of Distributor and Lubricator

permaPROMP-6Distributor -9-
351,5(forlubricatorswithPROLC250) 402,5(forlubricatorswithPROLC500)
75
45
4.3 Combination of Distributor and Lubricator
AfteryouhaveequippedthepermaMP-6withconnections,youcanconnectthedistributortoalubricatorofthe
PROrange.
Screw the distributor and the lubricator together. Attach both to the perma mounting device and install
the mounting device.
Direct Mounting of the Distributor onto the Lubricator
♦ Beforeyouconnectthedistributorandthelubricator,alllubricationpointsmustbepre-greasedandallgrease
linesmustbepre-lledwiththesamelubricantthatthePROLCunitcontains.Forthat,perma-tecoffersa
400glubricationcartridgeformanually-operatedgreasepresseswiththerequestedlubricant.
♦ ScrewthelubricatortightlyintotheG3/8threadofthedistributor.
♦ Positiontherearsidesofthelubricatorandthedistributoratonelevel.
♦ Attachthesuppliedmountingdevicetothedistributorandthelubricatorusingtheenclosedhexheadbolts
(M6x16)andthewashers.
♦ Screwthemountingdevicetogetherwiththelubricationsystemontoasupportofyoursystem.
Forthepositionoftheboresofthefourxingscrewsrefertogure6below.Youhavetousefourhexagon
screwsM6x25(e.g.onmetalground).
♦ Connectthegreaselinestotheconnectionsofthedistributorandinstallthetubescorrectlybetweenthe
distributorandthelubricationpoint.Tubelengthmaynotexceedvemetersperoutlet.
♦ Attachtherequiredconnectionstotheendsofthelubricanttubes.
♦ Whilethelubricationsystemisswitched offconnectthelubricatortothedistributorwiththeconnectingcable.
♦ Thelubricationsystemisnowreadyforoperation.
Ensure correct and tight assembly of the connections and grease lines to avoid possible leakage.
gure6
2hexheadboltsM6x16,
maximumtorque3Nm
(forattachingthelubricatortothe
mountingdevice)
2hexagonscrews
M6x25(forwall
mountingonmetall)
2hexheadboltsM6x16,
maximumtorque3Nm
(forattachingthedistributorto
themountingdevice)
2hexagonscrews
M6x25(forwall
mountingonmetal)