Input
60
Group
Parameter
Description
User level
Setting range
Set value
6
651 Presser foot with automatic lowering if the
machine is at a standstill
ON = yes
OFF = no
B, C ON -OFF ON
660 Bobbin thread monitoring
0 = without (= *II*)
1 = via sensor (= **I*)
2 = via stitch counting
A,B,C 0 - 2 0
668 Thread wiper / thread blower
ON = yes
OFF = no
B,C ON - OFF ON
7
700 Needle position "0"
(reference position of
needle)
B,C 0 - 255 0
702 Needle position "1" (needle down) B,C 0 - 255 80
703 Needle position "2" (thread lever up) B,C 0 - 255 226
705 Needle position "5"
(Magnetic thread trimming / end of cutting
signal "1", start of cutting signal timing "1")
B,C 0 - 255 200
706 Needle position "6"
(Pneumatic thread trimming / start of cutting
signal "2")
B,C 0 - 255 80
707 Needle position "9"
(Start of thread tension release / start of
thread catcher)
B,C 0 -255 164
715 Extension time for blowing and suction
after the seam end
B,C 0 - 2000 90
718 Standstill brake timing
0 = brake off
B,C 0 - 100 0
719 Timing adjustment A4 (presser foot) B,C 10 - 60 40
722 Acceleration ramp
1 = flat
50 = steep
B,C 1 - 60 50
723 Braking ramp
1 = flat
50 = steep
B,C 1 - 60 40
729 Start delay after lowering the presser foot [ms] B,C 10 - 2000 150
To Next Page
Loading...
