PFT G4 - Accessories

Mixing Pump PFT G4
Structure and function
2007-09-05 31
Pos: 4.18 /KN2006-SM/Auf bau und Funktion/010 1. 1 Zubehör_Titel @ 9\mod_ 1144440954953_29336 1.doc @ 293631
4.6 Accessories
Pos: 4.19 /KN2006-Pr ojekte/Knauf/Aufbau un d Funktion/Mischpu mpe PFT G4/Zubhör @ 12\mod_11 52028768183_293361. doc @ 298815
The following accessories can be ordered:
PFT injection hood E1 for G 4
(Item number 20 60 02 13)
The PFT injection hood is used for charging the mixing pump with
dry material with the aid of the PFT SILOMAT pneumatic conveyor.
PFT transfer hood with no-load safeguard for G 4
(Item number 20 60 05 00)
The PFT transfer hood is used for charging the PFT G 4 Mixing
Pump with dry material directly from the silo / container. If there is
an empty signal in the material container the mixing pump is
switched off via the remote control socket.
ROTOMIX D pumps complete with 35-series coupling
(Item number 20 11 80 00)
Agitator for better break up and blend of the material.
Direct drive through rotor studs
Contents approx. 1.2 l (0.32 US liq. gal.)
ROTOQUIRL II complete with 35-series coupling
(Item number 20 11 84 00)
Agitator for better break up and blend of the material.
Direct drive through rotor studs
Contents approx. 4.2 l (1.1 US liq. gal.)
Cellular wheel spacer disk for coarse grain plaster
(Item number 20 10 19 00)
Increases the cellular wheel's clearance to the floor of the material
container by 3 mm (0.12 inch).
Nozzle insert for water inlet with Geka coupling
(Item number 20 21 58 00)
For better injection of water into the mixing zone at low water
factor.
Pos: 4.20 /KN2006-SM/nL.......... Seitenumbruch .......... @ 8\mod_1141998334703_0.doc @ 293764