Mixing Pump PFT G4
Maintenance
2007-09-05 63
Pos: 8.11 /KN2006-SM/W artung/005 1.1 Reinigu ng_Titel @ 9\mod_1144436 963247_293361.doc @ 293729
8.2 Cleaning
Pos: 8.12 /KN2006-Pr ojekte/Knauf/W artung/Mischpumpe PFT G4/ Reinigen_ANSI @ 37\mod_11774 10228481_293361.d oc @ 447814
NOTICE
Water can penetrate into sensitive machine parts!
Prior to cleaning the machine, cover all openings that should
be protected against water penetration for safety and proper
functioning (e.g., electric motors and control panels).
After cleaning, completely remove covers.
The material container can be cleaned with a water hose after it
is completely empty.
Only clean the exterior machine parts with a damp cloth.
Pos: 8.13 /KN2006-SM/nL---------- Abschnittsende ---------- @ 8\mod_1141997892953_0.doc @ 293763
Pos: 8.14 /KN2006-Pr ojekte/Knauf/W artung/Mischpumpe PF T G4/1.1 Wartungsplan_Ti tel (Betriebsanlei tung) @ 43\mod_118511878700 1_293361.doc @ 544582
8.3 Maintenance schedule
Maintenance tasks that are required for optimal and trouble-free
operation are described in the sections below.
If increased wear is detected during regular inspections, shorten
the required maintenance intervals according to the actual
indications of wear.
Contact the manufacturer, if you have questions concerning
maintenance tasks and intervals.
(For the service address see page 2 of this Operating Manual.)
Pos: 8.15 /KN2006-SM/nL---------- Abschnittsende ---------- @ 8\mod_1141997892953_0.doc @ 293763
Pos: 8.16 /KN2006-Pr ojekte/Knauf/W artung/Mischpumpe PFT G4/1.1 W artungsplan @ 13\mod_11 52612274503_293361. doc @ 298850
Interval Maintenance task To be executed by
Daily
Clean/replace the brass sieve in the water inlet. Operator
Weekly
Knock off/replace the filter of the compressor. Operator
Every 2 weeks Clean/replace the debris collector sieve in the pressure
reducer.
Operator
Pos: 8.17 /KN2006-SM/nL.......... Seitenumbruch .......... @ 8\mod_1141998334703_0.doc @ 293764
To Next Page
Loading...
