Mixing Pump PFT G4
Operation
2007-09-05 43
Pos: 6.13 /KN2006-Pr ojekte/Knauf/Bedien ung/Mischpumpe PFT G4/1. 1 Mörtel auftragen_ Titel @ 36\mod_1177340371 179_293361.doc @ 445860
6.4 Applying mortar
Pos: 6.14 /KN2006-Pr ojekte/Knauf/Bedien ung/Mischpumpe PFT G4/1. 1 Mörtel auftragen_A NSI @ 37\mod_117740529754 5_293361.doc @ 447253
DANGER
Injury hazard due to ejecting mortar! Ejecting mortar can
cause severe eye and face injuries. Never look into the
sprayer. Always wear protective goggles. Always set up the
machine so that no one can be hit by ejecting mortar.
The possible delivery distance primarily depends on flowability
of the mortar. Heavy sharp-edge mortar has poor delivery
characteristics. Thin-fluid materials have good delivery
characteristics. If 30 bar (435 psi) operating pressure is
exceeded, then use thicker mortar hoses.
Fig. 36: Open air cock
1. Point the sprayer in the direction of the wall that will be
plastered.
2. Ensure that that no one is in the target area for the mortar.
3. Open air cock (
Fig. 36/arrow) on the sprayer.
The machine will start up automatically and the mortar will be
ejected.
4. Close the air cock (
Fig. 36/ arrow) for brief work interruptions.
It is also possible to operate the machine without compressed
air, for example for applying screed. To accomplish this, turn
the "Cellular wheel" selector switch to "Manual".
The mortar flow will start immediately.
Pos: 6.15 /KN2006-SM/nL.......... Seitenumbruch .......... @ 8\mod_1141998334703_0.doc @ 293764
To Next Page
Loading...
