Philips Efficia CM Series - Module and Alarm Specifications

Troubleshooting
Efficia CM Series Repair Guide 3-33
Error Codes
1036
System Error (1036)
Failed to start work
thread.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
1037
System Error (1037)
Cannot start polling
thread.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
1043
System Error
Work thread timed
out.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
1044
System Error
Front end software
error.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
1045
System Error
Printing software
error.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
1047
System Error
Monitoring software
error.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
1048
System Error
An exception was
detected in the
alarming software.
Shut down (see “Shutting Down the
Monitor” on page 4-1) and restart
the monitor.
If the problem persists, replace the
main board. See “Replacing the
Main Board” on page 4-27.
Code Description Possible Cause Action