4 Monitoring NBP
42
4
Insert the NBP Pod into the cradle.
CAUTION
Make sure that the air vent, located next to the air tubing connector on the NBP Pod, is not
covered during operation. If air cannot enter the air vent, the pump may be damaged.
Inspect the application site regularly to ensure skin quality and inspect the extremity of the cuffed
limb for normal color, warmth and sensitivity. If the skin quality changes, or if the extremity
circulation is being affected, move the cuff to another site or stop the blood pressure
measurements immediately. Check more frequently when making automatic or stat measurements.
Additional Information
The following documents contain additional information, depending on which accessories you are
using:
• Mobile CL Reusable NBP Cuffs Instructions for Use
• Mobile CL Single-Patient NBP Cuffs Instructions for Use
• Mobile CL NBP Cradle Instructions for Use
• Mobile CL Extension Air Hose Instructions for Use
Using a Carrying Pouch
As an alternative to fixing the NBP Pod on the cuff, you can insert it in a telemetry pouch which can
be worn. In this case the NBP Pod is connected via an extension hose to the cuff.
1 Apply the cuff as described in step 4 above.
2 Secure the pouch on the patient, with the upper ties around the patient's head and arm and the
lower ties around the patient's torso.
3 Insert the NBP Pod into the cradle.
4 Attach the extension hose to the NBP Pod in the cradle.
5 Insert the NBP cradle into the pouch.
6 Connect the extension hose to the cuff.
See the Accessories chapter for ordering details for pouches and extension hose.
To Next Page
Loading...
Need help?
General
